Skip to content

Homeowners     |     Contractors     |     Landscape Architects     |     Dealers

ROMEX® Permeability Calculator

How fast will your joints drain?

Enter your paver size and joint width. The calculator estimates the infiltration rate for four ROMEX jointing products, in inches or millimeters per hour.

Calculator

Enter your layout

Results update as you type. Switch between imperial and metric at any time.

Step 1Paver and joint

Dimension units
in
in
in
Example layout12 × 12 in pavers with 1/4 in joints, drawn to scale. Red is the open joint area that lets water through.

Step 2Infiltration rate

Rate units

Open joint areaAdd all three sizes

Estimates for clean joints, based on laboratory testing. Not a guarantee of field performance. Read the fine print

Open this page in a web browser to run the calculator.

How the estimate works

Joints carry the water

On a jointed surface, water drains through the joints. So the estimate starts with how much of your surface is open joint.

  1. 01

    Measure the open area

    The calculator lays out a 3 × 3 block of your pavers with their joints and works out what share of that surface is joint.

  2. 02

    Apply the product rate

    That share is multiplied by a fixed factor for each ROMEX product, based on laboratory testing.

  3. 03

    Read the rate

    The result is the estimated infiltration rate for the finished surface, in inches or millimeters per hour.

Before you rely on the numbers

What these results mean

Clean joints

Rates assume clean joints

The infiltration rates shown are based on clean joints. Over time, sediment and debris settle into the joints and slow the flow, so how clean the joints stay, and how often the surface is cleaned, will shape the rate you get in the years ahead.

Permeability and maintenance

Field conditions

Estimates, not a guarantee

Actual permeability in the field can vary widely with site and environmental conditions, including:

  • Base preparation
  • Installation quality
  • Joint fill
  • Slope
  • Compaction
  • Debris and sediment
  • Temperature
  • Maintenance

FAQ

Good to know

Why does joint width change the result so much?

Water drains through the joints, so the calculator starts from how much of the surface is open joint. A wider joint, or a smaller paver, leaves more of the surface open and raises the estimated rate. Change the joint width above to see it.

Will my finished surface match these numbers?

Treat them as a starting point. They are estimates based on laboratory testing of ROMEX products with clean joints. Base preparation, installation quality, joint fill, slope, compaction, temperature, sediment buildup and maintenance all change what you see in the field. Check the current data sheets and consult a qualified professional for project specifications.

How do I keep the joints draining?

Keep them clean. Sediment and debris build up in the joints over time and slow the flow, so how often the surface is cleaned matters as much as the product you choose. See permeability and maintenance, or ask our team about your site.

Which ROMEX product is right for my project?

Drainage is one part of the choice. The paver, the joint width and the traffic the surface carries matter too, and each data sheet lists the joint widths a product suits. The ROMEX Project Planner will narrow it down, or contact our team.

Questions about your project?

Our team can help you choose the right jointing for your pavers, joint width and drainage needs.

QUESTIONS?

Need some clarification? Contact our experienced and friendly team to learn more about our products and services.

ROMEX® NORTH AMERICA

New Footer

SUBSCRIBE TO
OUR NEWSLETTER